Search:

You must be a pretty young guy! Chevy used gaskets on exhaust manifolds for many years. Wasn't until the late 70's or 80's when they stopped putting gaskets on exhaust manifolds.

For headers, I...

This is a long shot, but I'm looking for the belt line trim for a '67-'72 Suburban Custom C10. This is the trim that sits right below the windows, and goes from the cowl all around the truck. Mine...

Good idea Steve. I don't have any, but I'll get some.

Good idea to put it in gas and soak it to test!
The last one had poor solder joints. They snap into the arm pretty easy, but the joint in the middle was bad, and there's a soldered hole on the end...

Before you buy a sender, test what you have to ensure the gauge is good. Pull the wire off the sending unit and turn the key on; it should go to "full". Then use a jumper to hook into the sending...

I hope somebody here can give some input to my float dilema. I had a sunk float bulb on my '69 Suburban, so I ordered a new float from Eckler's Trucks and put it in. All was fine again, but only for...

Might not work with things like a stereo, optional alarm, etc. that will pull current when the key is off. Best thing is to pull all the fuses and then install the test lamp between the battery...

3

Just checking! ;)

I'm not Carl, but yes all the '67 to '72 Burbs were three doors.

And what's with the site that a "three" comes up as a dancing hamburger????

Thanks Steve! Hope to see a lot of great discussion on Chevy trucks!
Mine is a 1969 C10 Suburban. Always in progress, like most hotrods are!
350 engine, TH400 trans, 12 bolt posi. 3.73 gears, HD...